These wavetables should work on all synths that use standard user supplied wavetables and have been tested on a Waldorf Quantum
27 wavetables – Various number of waveforms each, wave length 2048
JD-XA, Mother 32, Prophet 12, and Sub37 waveforms
Sampled and formatted by Paul Cotton
10 wavetables – Various number of waveforms each, wave length 1024
Waveforms from the same category: blended, perfect, saw, saw bright, saw gap, saw rounded, sine, square, square rounded, triangle
From adventurekid.se, formatted by Paul Cotton
Quantum instructions: Wavetable Oscillator > Timbre > Tools > Import from .wav > Set drive in upper left corner to Samples, USB Drive or SD Card > Select a file (eg the first one) > Set period to appropriate length 256, 1024 or 2048 etc. > Load. Then you can use the on-screen [prev] and [next] to move through the wavetable files.
Note: Firmware 2.0 works perfect, however on Firmware 1.3.0, your Import from .wav may not read the SD card, until you read it somewhere else. One solution is Wavetable Oscillator > Timbre > Presets > Export > Cancel > Close, and that will read the SD card so you can then follow the instructions above.
Trying to make sense out of all the wave* variant synthesizers out there today in 2020? Read the Uptown Oscillators Wavetable Synth Comparisons.
Be sure to join the
Uptown Oscillators Facebook Group
This page is a living document, subject to update and expansion.
Last edited – 1/18/2020
If you have any content you think should be added, or would like to help author gear pages/posts, please leave a comment here or on our Facebook group.